Try it before it ships.

These builds are not releases. Each one is here because somebody holding a board nobody else has offered to test it, and this is the quickest way to put it in their hands: plug the board in, press the button, and say what you saw in the issue it came from. A build stays here until it ships or is dropped.

Same flashing as the installer: desktop Chrome, Edge or Opera, over USB. The console will not offer to update from one of these, and it keeps its profiles and scores; to go back, install a release from the Install page.

Not a release · added 26 October 2026

Dual-USB 2.8-inch CYD with ST7789 glass (the CYD2USB)

For: 2.8-inch, resistive touch, USB-C plus micro-USB, no battery (USB power) -- ESP32-2432S028 CYD, ST7789 panel (ST7789 + XPT2046)

What to look atFlash it on a dual-USB CYD that draws washed-out colours under the inverted-panel image. Check that the colours are right in every theme (Settings, Device, Theme), that touch lands where you tap after the calibration wizard, and that the picture is the right way up in all four positions of the Layout button. Reply in the issue with a photo of the launcher under this build, and of anything that looks wrong.

Asked for in
issue 200
Built from
feat/cyd2usb-st7789, CI run 40331989547
Version
5.14.0-SNAPSHOT
This browser cannot reach a USB port. Open the page in desktop Chrome, Edge or Opera, or use the terminal route below. Web Serial needs HTTPS. Open the page at iamankushpandit.github.io/Gume.
Use a terminal instead
esptool.py --chip esp32 --baud 460800 write_flash 0x1000 bootloader.bin 0x8000 partitions.bin 0xe000 boot_app0.bin 0x10000 firmware.bin